AEG Dishwasher F55320vI0 — error i 10

[asp11]

This appliance is just over 2 yrs old and it suddenly stopped filling

I’ts not flooded in the base, the pump works fine but it won’t fill….. after a few minutes comes up with an error….. small vertical line on left then 10 on right of the display window

During my visit and after the initial pump out it was silent, I heard No clicking from any relay or buzzing from anything else until the error appeared

This makes me think the fault is with the PCB (which is sited around the back, weirdly)
ANY HELP PLEASE?

Thanks
Brett

[adv]

will need the pnc number

[electrofix]

i10 is just a no fill tap closed type error

have you checked for tap closed , kinked hose, solenoid faulty

Dave

[asp11]

Enr : 911536103-06
Ser : 71612762

I have checked the basics but am concerned that there’s no clicking from any relays after the initial pump out… it just goes silent for a while until the error appears then it pumps again and stops??

[electrofix]

well if its trying to get water and that does not happen that’s not surprising

I would check valve coil first

long shot have you looked at the inlet hose. the valve is at the tap end so that means there is a cable running down the tube with the water inlet hose. Have they had mice eating it ?

Dave

[asp11]

I’ll double check…. Thanks

[clockworkone]

Def worth looking at the tiny pr sw. A real problem area on these. Easy repair. I carry a syringe with small tube connected to end of it to flush it out through tiny hole in in sump, works a lot of the time.Paul.

[Author]

Posts