- This topic has 7 replies, 2 voices, and was last updated 3 years, 6 months ago by
.
-
Posts
-
Hi, I have an aeg lavatherm 7000 and the dryer is not collecting water in the draw. It has suddenly stopped, and now all that happens is a lot of condensation In the utility room.
well that means the damp air is getting past one of the seals
are you sure the condensor is clear as well as the filters ?
Dave
The condensor was a bit blocked but as it fixed in the unit I cleared what I could. The filters are clean. The water pump is working..the front door seal has been replaced. I’ve checked seals and they seem fine.
It’s as though the water isn’t getting to the water pump
there is steam escaping into the casing
you just have to find out where
do my trick, fill it full of wet washing and with the lid off run the machine. then get a mirror or a pair of glasses and move it round to see if it fogs up
daveOK I’ve got a load to go in there this morning, I’ll give it a whirl. Will let you know if I find anything
OK, there seems to be hot air coming out where the front of the drum. As it spins I feel it on my hand….should this be air tight?
Front gasket seal
you may get warm air blown around the case but the important thing is
is the air wet or dry
dry air is fine but if moisure is in it you have a seal problem
Dave
- You must be logged in to reply to this topic.