awp510

[robbo1973]

Hi all this customer always uses the same quick cycle but she said recently when cycle is finished it beeps but doesnt stop beeping,she says it goes thru cycle and washes etc fine but she runs it during the night so the beeping is annoying.

I changed the pcb incase it was that and checked everything else but its still doing it.

any thoughts?

[Dales-Electronic]

Re: awp510

This constant beeping at the end indicates a fault during the wash cycle if you check out the wash, rinse & spin leds note what each is doing and refer to the error codes this will direct you to the fault.

[robbo1973]

Re: awp510

hi thanks for reply,after she said there was defo no lights flashing she has looked again and the spin is flashing and the start is flashing nothing else?

[Dales-Electronic]

Re: awp510

Forget the start light – if only the spin light is flashing this indicates – I quote, door not closed correctly, but from experience it is usually either the PCB or the loom from the pcb to the interlock.

[robbo1973]

Re: awp510

thats strange as its doing the cycle ok and when its finished she always spins off again and that is fine as well but does flash at the end.

[washtronics]

Re: awp510

constant bleeping at end of cycle is a open circuit heater.

[Dales-Electronic]

Re: awp510

Or faulty loom or pcb

[robbo1973]

Re: awp510

heater is fine and the pcb has been changed

[Dales-Electronic]

Re: awp510

Loom/thermistor then

[Author]

Posts