- This topic has 0 replies, 1 voice, and was last updated 10 years, 4 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hi, trouble started with no error code just the digital display stating no water was going jn to the machine.
The inlet solenoid on the water feed pipe was open-circuit so I replaced it.
Now the solenoid is constantly being energised, so the machine is displaying error F9.
From the moment of plugging the machine in, the solenoid is powered. The only time that power stops to it is when I open the door. The instant I close it, the solenoid is energised again. I’m assuming this being constantly powered is what caused the original to go open-circuit.
Can anyone please advise on possible cause?
Thank you
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.