- This topic has 0 replies, 1 voice, and was last updated 20 years, 1 month ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Been to look at a Baumatic Integrated Dishwasher BDW11, it is not accepting programmes when you select them. On switch on bell rings, but no programme led’s light up. On/off led does not light, but supply is OK on load side of switch. If i switch off, i can enter programme, just for a few sec’s & then leds in programe sequence light up, programe does not function correctly, most times tripswitch goes off. This happens with heater, disconnected, pump, disconnected & circulation pump disconnected. There is no water in base of machine & loom looks good in door etc. Any ideas?
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.