Beko DIN28Q20 dishwasher not starting

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko DIN28Q20 dishwasher not starting

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • June 5, 2020 at 2:19 pm #97764
    DPDOM
    Participant

    Hi
    Called to this newish Pro Inverter dishwasher
    today and I can set the program and when the door is shut there is a very short clonk from inlet valve opening but then it goes dead and no red light on floor.
    If i reset it the drain pump will run and i can also seem to get it on test mode by holding the first 2 buttons and have managed to get it to fill and circulate but thats it. Not really sure what to do in test mode.
    Anyone got any info?

    Kind regards

    Dave

    June 5, 2020 at 2:20 pm #469362
    DPDOM
    Participant

    Door wires all ok.

    June 5, 2020 at 7:47 pm #469363
    electrofix
    Moderator

    need an email add and will send you what i can find

    Dave

    June 5, 2020 at 9:05 pm #469364
    DPDOM
    Participant

    dave@davidpeirce.com
    Thank you

    June 5, 2020 at 9:11 pm #469365
    electrofix
    Moderator

    ok check your email

    Dave

    June 6, 2020 at 11:18 am #469366
    kaibart
    Moderator

    Check or change the led wiring that shines red light on floor they cause loads of odd faults

    June 8, 2020 at 3:15 pm #469367
    DPDOM
    Participant

    Thanks guys. I’m going back at the end of the week.

    June 15, 2020 at 5:16 pm #469368
    DPDOM
    Participant

    It was the pcb.
    Cheers

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.