Beko DSC85W only gets clothes luke warm

[GingaPete]

electrofix wrote:to be honesty if the board has gone it will be a small surface mount resistor so you may not see any burn marks

had a beko dryer with similar problems ie tripping RCD. Replaced heater with new and tripping stopped but still no heat. traced wired from heater NTC to board and traced tracks to find blown surface mount resistor (very small component can only see its blown with magnifying glass). replaced resistor and all was well

Dave

OK, i have a desk mounted magnifier with light for cutting stencils so could be worth a look see if there is anything that shows up, my uncle can do board work did some on a meile vac for me once. Do you know where i can get a schematic for the dsc85w as i can’t find one? Cheers Dave

Pete

[electrofix]

no schematics of any appliance boards. We just wing it as they say

Dave

[Specialist01269]

Dave’s right: Manufacturers don’t supply any board schematics, that would make our lives too easy :). Besides they don’t want us fixing things, it costs them money.

[GingaPete]

Guys, found out what the issue was!!! Wrong pcb!! I had a mate check the board (he’s into board repairs and small units) and he said nowt wrong with it. So i emailed supplier to ask about board and they emailed to say I had wrong board supplied, so they sent a new one popped it in and we now haveheat!! So the other board will be going back this week!!

Thanks for responding I know I was a bit vague but all sorted now!

Hope you have a boss crimbo 😉

Pete

[Author]

Posts