Beko wm 8127w diagnostic mode

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko wm 8127w diagnostic mode

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 24, 2014 at 5:13 pm #81197
    bmrenr
    Participant

    Hi can you get into diagnostic mode on above m/c? I have been to this and all it will do is let in the water and the drum will turn a few times and just stop and do no more. I have checked the brushes and control board and look ok.

    Tom

    June 25, 2014 at 7:03 am #415746
    Seamy
    Participant

    Re: Beko wm 8127w diagnostic mode

    Does it fill to correct level, maybe blocked pressure vessel, hose etc or heater low or open circuit.

    July 1, 2014 at 4:34 pm #415747
    bmrenr
    Participant

    Re: Beko wm 8127w diagnostic mode

    Hi seamy yes it was filling to right level turned out to be main board I found the diagnostic mode In known test procedures I should have looked there before posting.

    Thanks

    Tom

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.