Beko WMA 765S – Module Prob?

[MickGeorge]

Hi Folks

When to this one yesterday – no fill – wash prog times out – put on spin display says 20min? – does first intermediate spin then shuts down after about 2mins – no lights flashing and don’t seem to be able to select wash variants.

Checked heater for earth faults – motor seems ok as rotates in wash mode and goes into first spin – door locks up ok..

Before I order module am I missing anything as not done Beko computer types before – would suspect flashing lights if module diagnosing fault? – Tried to put in diagnostic mode as listed in UK Whitegoods faults book but unable to do so.

Presumably module comes complete and no eproms to order..

Anyone know what the small module at the back right hand side does? – looks like some sort of mains voltage regulator as main wiring goes into it from mains wiring and out again to main board – parts list it as dc module?

Comments grately appreciated as usual..

Thanks

Mick

[rocker]

Re: Beko WMA 765S – Module Prob?

give Emw a ring they will give you tec advice and exchange board if required also returnable if not required. John
I use them all the time.
EMW 01159 652118

[MickGeorge]

Re: Beko WMA 765S – Module Prob?

Thanks John

Already tried EMW as like you I use them a lot but they don’t do that board..

so any other help appreciated

Mick

[Author]

Posts