beko wma510w

[gramp]

this out of balance problems that i have read about stopping machines from spinning
can the replacement of the pcb make any difference to this problem or will it still remain the same

[kwatt]

It would be the same I’m afraid.

There is one manufacturer I know of that makes OEM machines that has had such a severe problem with this that they have produced a PCB with a lesser sensitivity to OOB. Whether it works or not is open to debate.

K.

[helo_75]

if u mean the haier machines,, then no
even the new pcb need reprogramming with the right software

[gramp]

Re: beko wma510w

i have looked at 2 of these this last week with same problem and landlord is thinking of going ahead with the pcb change .
but reading your replies i think i will advise against this .
thank for any input

[Author]

Posts