Beko WMA765

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko WMA765

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 18, 2009 at 12:25 am #43567
    Mully
    Participant

    Hi all,
    I’ve been to a Beko WMA765 today, one year old, halve full of water. you can set prog but it will not start, wash light flashing.

    Ran the test prog as per page 6 of ukwg fcg all ok but slow to empty, cleared pump filter, now empties ok.

    Still no start on any prog, wash light still flashing, door locks ok, fill levels on test ok.

    Any ideas or sugestions .
    Thanks John.

    February 18, 2009 at 5:52 pm #277722
    funkyboogy
    Participant

    Re: Beko WMA765

    CONTROL MODULE ,
    had a few of these…dont think their to expensive
    ally

    February 18, 2009 at 9:54 pm #277723
    smartin
    Participant

    Re: Beko WMA765

    i would be checking the carbons me self 😉

    February 18, 2009 at 11:22 pm #277724
    Mully
    Participant

    Re: Beko WMA765

    Thanks for the replies, the carbons are fine and it goes through the test

    cycle ok with motor action both ways and ramps up to full spin.

    I will price up a mod tomorrow.

    Thanks, John.

    February 21, 2009 at 5:14 pm #277725
    Tony_EMW
    Participant

    Re: Beko WMA765

    £34.90+vat http://www.emwelec.co.uk

    February 21, 2009 at 9:58 pm #277726
    franz
    Participant

    Re: Beko WMA765

    £30.03 +vat from Connect

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.