belling range

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › belling range

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 24, 2019 at 9:54 am #96609
    mikehha
    Participant

    hi all I have a belling range with a induction top which is coming up with er22 have checked the control board all looks good and have made sure that the springs were in touch with the glass any thing else to look at or is it a new board.

    October 20, 2022 at 7:47 am #464047
    matrixresonator
    Participant

    Resurrecting an old post, but did you manage to find anything out about this? Just had a customer enquire about the same error.

    October 21, 2022 at 10:45 am #464048
    mikehha
    Participant

    sorry no. it was in a learning center and they would not wait for me to find out so they bought another one.

    October 21, 2022 at 10:57 am #464049
    matrixresonator
    Participant

    Apparently its on overheat fault, all cut outs tested good and fans all running so I put it down to a failed PCB.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.