Bosch D/W Dispenser Problem

[Turbo]

Model SGS66A02GB/13 FD8203

Hi
I have tried to fit Prt No 490467 supplied by Bosch but the rinse aid connector won`t plug into the pcb sensor on the new dispenser unit.

Hoping for some help please!

Graham

[electrofix]

Re: Bosch D/W Dispenser Problem

well its the correct part for the model so should be ok

Dave

[Turbo]

Re: Bosch D/W Dispenser Problem

Thanks for the reply Dave.

The new dipenser has the rinse aid connector on the left side of the unit and not the bottom as is the case with the old one.
Not that the position matters, it`s just the plug doesn`t fit.

Thanks

Graham

[Turbo]

Re: Bosch D/W Dispenser Problem

Another thing I should have mentioned is that my plug only has 2 wires and yet the new PCB has 3 connector points on the rinse aid PCB.
I have just watched a couple of youtube videos on fitting this part and both had three wires to that plug.

Graham

[electrofix]

Re: Bosch D/W Dispenser Problem

not sure what the third wire is for but all you need to connect to is the reed switch for the rinse aid

Dave

[Author]

Posts