Bosch Exxcel dishwasher module

[kram]

I have an 8 yr old Bosch dishwasher …

SGS4442GB/01
today the control PCB blew.
Bearing in mind its has been v reliable and otherwise is in good condition
do you think its worth changing the PCB out since Bosch want £100 for a new one ?

I could send it to QER but I’ll still be looking at £50 + and have never used them before.

How likely is it that another component has blown and caused a mains spike to fry the PCB ?. Both pump motors test OK door loom looks good.

BTW I’m and ex self employed washer basher – now a hire company service engineer.

Any opininions appreciated esp’ from Bosch techs.

Cheers

[leavemetogetonwithit]

Re: Bosch Exxcel dishwasher module

Depending on how bad the damage is, you could have a go at repairing the board yourself. Often it’s just a relay joint on Bosch dw boards. Might look worse until you clean away the burn marks.
Mike.

[kram]

I’ve took the board out but sadly its BER.

One of the relays has well and truly blown, lifting tracks, so I guess QER is out as well.

Guess its time for a new washer.

I always buy Bosch everthing. How much better are the Exxcel range over the ‘base’ SGS range anyone ?

Worth the extra £50 ?

[Penguin45]

Re: Bosch Exxcel dishwasher module

Treat yourself and get our ISE5 machine.

Nice………. 😀

Chris.

[Author]

Posts