- This topic has 5 replies, 3 voices, and was last updated 3 years, 10 months ago by
.
-
Posts
-
Got a Boscg Classixx 6 Varioperfect 1200 800 and 600 lights flashing, needed new carbons but tried a few different re set but no luck, anyone know the reset for this one?
Thanks
Dopthere are a couple of resets i know of
Dave
Thanks for everyone who got back to me about this enquiry especially all you Siemens engineers out there (yes you know who I am talking about) after some digging I finally found the solution
1.Turn off the machine (dial to 0)
2.Open the door
3.Turn on the machine on first program
4.Close the door
5.Turn off the machine
6.Turn on the machine on the “six-o-clock” program, which is centrifuge
7.Press the “option down” button and keep it pressed (This is the button left of the display)
8.Turn the dial to “seven-o-clock” (empty/pump out program)
9.Release the “option down” button
10.Turn of the machine.wak machines
from off press and hold start turn knob ONE “not two” clicks left after about 10 seconds an odd display shows, turn off all now seems ok.
wab machines
1) Close the door (The following operational sequence must take place after switching on the appliance)
2) Set program selector to OFF position
Wait for at least 2s
3) Set program selector switch to position 15 while the Start/Pause button is pressed until display is active
4) Release Start/Pause button
All remanent errors will be resetDave, you forgot the, roll one trouser leg up, turn round three times and whistle ‘Please release me’ at the same time.;)
iadom wrote:Dave, you forgot the, roll one trouser leg up, turn round three times and whistle ‘Please release me’ at the same time.;)
dont you have to pat your head and rub your tummy as well lol
Dave
electrofix wrote:
dont you have to pat your head and rub your tummy as well lol
Dave
Only when there is a full moon.:D
- You must be logged in to reply to this topic.