- This topic has 2 replies, 2 voices, and was last updated 17 years, 5 months ago by
.
-
Posts
-
I have just been recalled to a Bosch WTE6920GB/01 intergrated dryer, the display shows — and it will not start or except a drying programme. The original problem was the water container full light staying on, so I have cleared a blockage in the pump housing. Tested m/c before leaving and it appeared to be working fine. I have been back and checked all usual suspects heater, TOC, door lock etc.. anybody know what this might be?
would be grateful for any advise
OscarRe: Bosch tumble dryer
Many thanks Superfix you were spot on… she had lost the Instruction manuel in the instruction manuels drawer! :rolls:
But just in case anybody else falls for it, the child lock is locked / unlocked by holding down both “select” and “change” additional option buttons for five seconds. Those five seconds could save you an hour or so pulling the thing out again and checking just about everything else!!! errr not that I did 😳
- You must be logged in to reply to this topic.