Bosch WAE2416SGB/01

[geoffmackay]

8605 100122

Went to this one about a week ago with no drum action. Changed carbons, which were usual worn out state. Still no joy, checked module and found blown track. Replaced module and reprogrammed it. Machine ran fine. Now after 5 washes it appears to be flashing a fault code. In the row of spin speed lights 1200 (top),800 (middle) and rinse hold (bottom) are flashing and machine wont do anything. Any ideas chaps?

Regards
Geoff
Carlisle

[bosch-engineer]

Re: Bosch WAE2416SGB/01

It sounds like it was the motor in the first place which blew the original module. Did you trace the tracks which had blown off to see which component they supplied. The fault code you are seeing now indicates a motor fault (motor not tuning). Check to make sure the new carbons you fitted are not sticking in the holders. It may require a new motor or at least a strip down to clean all the carbon build up, which can cause module faults.

[geoffmackay]

Re: Bosch WAE2416SGB/01

Great thanks for that. Suspected a motor fault. Machine now in our workshop so will take a look in the morning.

Thanks again

Geoff

[Martin]

Re: Bosch WAE2416SGB/01

bosch-engineer wrote:. It may require a new motor or at least a strip down to clean all the carbon build up, which can cause module faults.

And another module. 🙁

[Author]

Posts