bosch WAE24469gb short spin

[slyp98]

Hi guys , this machine on spin 12 min cycle starts into it , immediately no reverse tumble just one direction spin gradually building up to 700 rpm then at 8 mins jumps to 3 mins goes to full speed for 60 seconds then stops , control board ??

[Martin]

Re: bosch WAE24469gb short spin

You must remember that on these the SPIN ONLY cycle is a short programme that spins at low speed ONLY. As it is meant for HAND WASHING ONLY…!

So the PCB is not something I would suspect as being at fault. However if it does it on (say) a Cottons cycle then and only then would I investigate further.

P. S. Please remember in future to give us the FULL model number including the suffix, it helps us more. 😉

[slyp98]

Re: bosch WAE24469gb short spin

Customer complaining of no spin i couldn’t wait for a full cycle so i just thought put it on a spin cycle 12 mins , just figured it wasn’t working right when digi display jumped from 8 to 3 mins

[Martin]

Re: bosch WAE24469gb short spin

Well there you go, you learn something new each day I guess. 😀

[slyp98]

Re: bosch WAE24469gb short spin

Its a good day you learn something new Martin

[slyp98]

Re: bosch WAE24469gb short spin

customer still complaining of spin problems , none as far as I can tell any ideas , brushes fine

[Martin]

Re: bosch WAE24469gb short spin

Have you Meggered the motor? Any earth leakage will give spin timing issues as it effects the fuzzy logic processor.

[Author]

Posts