- This topic has 3 replies, 2 voices, and was last updated 10 years, 11 months ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
Been to this this morning for ‘no spin’. It’s emptying fine and runs through distribution ok, but as soon as the spin starts it aborts and returns to distribute, even with no load. Pressure chamber clear, so suspecting the stability sensor. Anyone had this before ? Thanks in advance, Wiz.
Re: Bosch was32461gb/14 no spin
Hmm, hoped it wouldn’t be that. Have you had any problem with these boards Martin? Doesn’t look like there’s much that can be replaced on it without changing the pcb complete & don’t think the customer is likely to go for that.
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.