- This topic has 2 replies, 2 voices, and was last updated 17 years, 7 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Fitted new motor brushes to this today, which defo needed.
Afterwards would start spin at 11 mins, spin until 9 mins then
reset to 001, stop spinning and end program.
Examined pcb for dry joints etc none found.
After replacing, span bit faster but reset to 001 after 8 mins on display.
Has vague idea this may be out of balance fault due to brushes bedding in.
Am I hoping for too much?
If so any ideas?cheers in advance folks.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.