Bosch Wdrier. WVD24520GB/08. FD 9102 pump run and abort.

Home Forums Trade Technical & Spare Parts Forums Trade Technical Enquiries Bosch Wdrier. WVD24520GB/08. FD 9102 pump run and abort.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #96030
    Rograbbit
    Participant

    Hi. This washer dryer. You turn the selector after about 15 seconds pump starts to run without pressing start. If you press start pump runs for a couple of minutes then unlocks door and aborts programme. Heaters ok continuity and insulation. Occasionally customer got to start then completes program. Looks like pcb? Haven’t had brushes out do these throw an f21?

    #462112
    electrofix
    Moderator

    don’t forget bosch don’t make this one as far as I know, so have you checked brushes?

    Dave

    #462113
    Rograbbit
    Participant

    Thanks Dave. No I haven’t, although it has worked when they’ve got it to start. Mind you he told me before I left a new McDonald’s built round corner, drawing too much power and the supply voltage to the house all over the shop. They had electrician in. Just wondering if there’s been any transient spikes that’s done some damage to board.
    Thanks again
    Roger.

    #462114
    electrofix
    Moderator

    if the electric was that bad I would have expected other electronics would have had problems but yes it is possible

    but its also possible the brushes make and break so work sometimes

    cant hurt to check

    Dave

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.