CANDY CDI 1012

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › CANDY CDI 1012

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 5, 2008 at 4:41 pm #40783
    mendy
    Participant

    I see there was a question recently about the motor pulsing.My one fills,motor cuts in,runs for a few seconds , stops then fills again a few seconds motor cuts in etc.As the last question,could this be pcb or are there air break blockages common etc.Any help appreciated.All the best.
    Mendy.

    November 5, 2008 at 7:35 pm #267533
    smartin
    Participant

    Re: CANDY CDI 1012

    siphoning would be my 1st choice, failing that i have had the same fault caused by pressure sensor

    November 6, 2008 at 9:44 am #267534
    electrofix
    Moderator

    Re: CANDY CDI 1012

    you did not mention that the machine was overfilling and flooding so i am assuming this does not happen

    so i agree with smartin the water must be exiting through the outlet hose take it out and hold it in a bowl or over the sink if u can see if it runs then

    Dave

    November 7, 2008 at 6:13 pm #267535
    mendy
    Participant

    Re: CANDY CDI 1012

    Many Thanks, I’ll give it a try.All the best.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.