Candy CMD156 Jumping around!

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Candy CMD156 Jumping around!

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 8, 2010 at 10:26 pm #56381
    subs
    Participant

    Ive repaired this washer dryer twice in the last 18 months. The first time the machine jumped around so much on a spin cycle the filter housing cracked and the water flooded out onto the kitchen floor. The second time the tub bounced about so much it smashed the surpressor to bits and damaged the ribbon cable to the board. It has now cracked the filter housing again. It does not do it all the time but if you push and bounce the tub manualy with the lid off there is a lot of play and it hits the surpressor without too much effort. Any ideas? New Shocks?

    Subs

    August 9, 2010 at 8:51 am #327097
    Martin
    Participant

    Re: Candy CMD156 Jumping around!

    subs wrote:New Shocks?

    Sounds like it to me. Best to unhook each one in turn to find the faulty one to be sure. If one is duff then best replace both. Incidentally, can’t find a CMD156 on the Gias site for some reason? They only show a CMD146…..hey ho!…Italians eh, what are they like? 😉

    August 9, 2010 at 9:24 pm #327098
    subs
    Participant

    Re: Candy CMD156 Jumping around!

    It is a CMD146 that was a typing error I think!
    I’ll try replacing the shocks.

    Thanks

    Subs

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.