CANDY CNL 135

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › CANDY CNL 135

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 23, 2008 at 12:31 am #33982
    simonb
    Participant

    Spin fault on above machine, seems to wash fine, on spin sits idle, also when tried on spin only a few times with no avail, although it seemed to have a go for a few seconds one 1 attempt

    the customer has replaced the brushes her self, but put one brush in the incorrect position so they were not inline on the comm, without indepth thought i guess this would inbalance the circuits within the comm, although it did wash ok like this, the old brushed i was told wasent worn right down?

    i took control module off and no sighs of blown tracks or dry joints,


    simonb

    January 23, 2008 at 7:16 am #240775
    bobokines
    Participant

    Re: CANDY CNL 135

    Check it on wash to ensure drum is reversing!

    Bet it’s only going one way… If so it’s a faulty relay on the board (or a dry joint that you have missed)

    Bob

    January 23, 2008 at 7:42 am #240776
    admin
    Keymaster

    Check DC voltage on one of those coil relays (not on switching contacts) if is around 24V when is activated…

    January 24, 2008 at 12:25 am #240777
    simonb
    Participant

    Re: CANDY CNL 135

    thanks iv check again no dry joints , this is what i first thought cos iv seen that on these boards before just a blob and its fixed,

    regarding checking the relay im not to confident with live testing on boards, thanks anyway

    simonb

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.