Configuring Zan board!

[Goatboy]

👿 👿 👿

Typical for a Friday afternoon!

I’ve got a ZWF1432 that needs a new board. Easy enough, put in on, go to configure it, and there’s no ‘L10’ position. It only seems to go up to L8!

The tech info I have is for the m/c with an digital display (L10 for configuring).

So does anyone have the tech info for this m/c, please. Or can anyone tell me how to enter the 16 digit code into a Zan m/c without a digital display?

Thank Q!

[Goatboy]

Re: Configuring Zan board!

I been talking to Zanussi, and they say all the board are the same :/

L10 to configure them, but Mine only goes to L9 then back to L0. Hmmmmmmmmmmmmmmmmm 🙁

[DentedPorsche]

Re: Configuring Zan board!

Hiya,
Appears to be 4 versions of that machine.
EMW1000 electronics on it. The only board on the TDS disc is a pre-configured board.
There’s another thread about this somewhere, basically, can’t program the blank ones from the machine.
http://www.ukwhitegoods.co.uk/modules.p … highlight=

Brian

[Goatboy]

Re: Configuring Zan board!

Cheers dude 🙂

That explains everything.

[Seamy]

Re: Configuring Zan board!

Price wise theres no real incentive to order non configured boards.
Think for less than a fiver difference i’d go for the configured one.

SideKick software is now being inroduced to Service Force engineers which will allow these non configured boards to be programmed via a laptop & interface connection rather than twiddling knobs & entering codes

[bassman]

Re: Configuring Zan board!

I,m sure I have done this in the past if I remenber right try using L0 instead of L10

[Author]

Posts