Creda TVU1

[delta01]

This dryer wont keep going ,when you press the start button it stops when you release it i suspect a relay there is a small circuit board behind the Facia , however looking on this forum someone suggested that some models have a relay in the lock any help appreciated Thank John

[electrofix]

Re: Creda TVU1

if the board looks like

https://shop.ukwhitegoods.co.uk/1703616 … -relay-pcb

then I would assume this would keep the dryer going and the door lock would just be a simple switch

Dave

[delta01]

Re: Creda TVU1

hi Dave the board is similar but only has 3 connections

[electrofix]

Re: Creda TVU1

post a pic of the board

does the board contain a relay or is it just a buzzer board ?

when I put the model into Qualtex both types of door lock come up so it looks like the model range uses both depending on commercial codes

Dave

[iadom]

Re: Creda TVU1

Only one comm code for this model, differences are serial number related.

That is also the only relay listed for this model, not sure if that picture is correct but only three terminals are used either way.

I will send the manual to the email address I have for you from 2011. 😉

Jim.

[delta01]

Re: Creda TVU1

Thanks all for your help John

[delta01]

Re: Creda TVU1

Hi I sorted this the small panel behind facia just needed some capacitors I replaced the oblong one adjacent to the relay and three small round ones
Only cost a few pounds I would put a picture but don’t know how to
Hope this is useful
John

[electrofix]

Re: Creda TVU1

to add picture. go to the full editor. scroll down the page till you see a tab labelled “upload attachment”. click this then browse your device for the photo and add

Dave

[Author]

Posts