Diplomat ADP8132 Fault

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP8132 Fault

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 13, 2007 at 9:35 am #28094
    AndyChap
    Participant

    Our dishwasher has developed the following fault on selecting any cycle, even after a reset, the machine tries to start the drain pump and it operates for about 1-2 seconds and then the machine beeps. This then continues every 10-15 seconds with the pump operating and then the machine beeping. The only lights showing are the selected cycle. I have taken the drain pump off and checked it and it does work ok. There are no obvious blockages. The machine is about 6 years old with no previous problems

    Any help would be appreciated.

    June 13, 2007 at 7:17 pm #216880
    Penguin45
    Participant

    Re: Diplomat ADP8132 Fault

    Sounds like a fairly classic PCB failure to me…….. You might like to consider replacing the soap dispender at the same time – there are a lot of PCB failures at the moment due to dodgy dispenser solenoids.

    Timer/PCB – 816290672
    Dispenser – 812890059

    An email to spares@ukwhitegoods.co.uk for prices and ordering.

    Regards,
    Penguin45.

    September 13, 2007 at 5:15 pm #216881
    skinut
    Participant

    Re: Diplomat ADP8132 Fault

    Hello AndyChap,
    Our dishwasher has just developed the same fault, did you manage to get yours sorted. like you i’ve checked the drain pump and tried to reset the washer with no success. Any help would be much appreciated.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.