Diplomat ADP8332 F3 fault

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP8332 F3 fault

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 13, 2007 at 7:23 pm #29741
    sharont1111
    Participant

    I have had a ‘scan’ around trying to find any similar posts.
    A recomendation was to remove panel and press reset button. Well, eventually managed to remove panel but can’t locate button? I can see a red block on the left, is this anything to do with it?

    August 13, 2007 at 7:57 pm #224297
    Penguin45
    Participant

    Re: Diplomat ADP8332 F3 fault

    This is a heat failure. There is no re-set BTW.

    Most likely failure is heater, then wiring. PCB can play up, but relatively rare.

    Power off, if you are going to investigate,

    Regards,
    Penguin45.

    August 14, 2007 at 8:52 am #224298
    sharont1111
    Participant

    Re: Diplomat ADP8332 F3 fault

    Thanks for the reply, I ended up being mad and pressed lots of buttons keeping the start button pressed for a while (as women do)!

    Guess what – the fault light went off and a ‘trial’ rinse worked!! Could be fluke only trying a full wash tonight……………

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.