DRCS 68W condensing drier

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › DRCS 68W condensing drier

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 23, 2011 at 7:02 am #65236
    aqua_serve
    Participant

    Guys,

    Having had hardly any experience of Beko appliances I wonder if one of you might be able to point me in the right direction with regards to a Beko DRCS 68W condensing drier.

    After selecting a program the drier operates as usual until about 3 minutes in. At this stage the machine bleeps a little melody before the Clean Filter and Water Tank Full LEDs light. The End/Anticrease led also lights.

    Turning off the machine and restarting appears to reset the error, but selecting the same (or another) program the same happens again.
    I can’t seem to find any error codes on here that give me any pointers so any advice would be well received. ?

    Mark

    September 23, 2011 at 4:48 pm #359781
    scots
    Participant

    Re: DRCS 68W condensing drier

    Try checking pump or blockage pump to container hoses?
    Have changed the pump recently in one of those
    Would explain tank full light

    Brian

    September 24, 2011 at 9:58 am #359782
    Seamy
    Participant

    Re: DRCS 68W condensing drier

    As its a sensor dryer it will need damp clothes in drum to run on auto’ programme, if none are detected it assumes clothes are dry & plays a happy melody to tell you its finished. Timed drying should heat without regard for sensor which is located inside bottom of door. Clean Filter & Water Tank Full comes on at end of every cycle as a reminder to customer.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.