Electrolux DW ZSF6160

[a1al]

Hi everyone

I have just fitted a new pcb to this dishwasher to fix a no heating fault, but the new board does not even light up there is 230v at the input terminals. Anyone come accross this before????

Alymer

[admin]

Do you have there two distinctiv wires on the left PCB (which get into A1 and A2).
Did you switch themselves? (A1 comes from live=blue wire; A2 comes from heater=orange wire) :hmm:
or the next connector (B1 from neutral;B2 from door switch) :hmm:
8)

[a1al]

Re: Electrolux DW ZSF6160

Hi Baron

There is two wires on the left of the PCB
I dont think I switched them around, I think they were in a plug.

Do they need to be switched around

Thanks

Alymer

[admin]

Verify if wires goes where is writen above…
Those A1;A2;B1;B2 is writen on PCB and should go where is writen… Check also door switch.

[a1al]

Re: Electrolux DW ZSF6160

Hi Baron

I will check this out

Thanks for now

Alymer

[a1al]

Re: Electrolux DW ZSF6160

Hi baron

Finally received new pcb and returned to repair found that I had switched the wires around on the first connector

Many thanks for the help and a happy new year to you and your family

Alymer (a1al)

[Author]

Posts