Element

Viewing 12 posts - 1 through 12 (of 12 total)
  • Author
    Posts
  • #102956
    neelie
    Participant

    Iv been given an INDESIT DD60C2CX Electric Ceramic Cooker the grill doesn’t work but the grill element is not connected to the wires and rather than plug them in wrong to try Im not bothered for a grill.. can these element wires be removed altogether from whatever they connect to in back of cooker

    #491205
    electrofix
    Moderator

    you can do or just reconnect them to the element in any order and should be safe

    why were they disconnected do you know ?

    Dave

    #491206
    electrofix
    Moderator

    no thats been taken out and they even left the wires in the correct places so if you get a new element we can get it going

    also you seemed to have used your email address as your forum name. This is a public forum so anyone can see it and send you sll sorts of things you dont want

    Dave

    #491207
    neelie
    Participant

    the white wire is damaged halfway through showing bare wire, is there not a terminal block in back of oven that i can disconnect the wires from and omit them altogether and not have a grill as i dont need it i dont have cooker though

    #491208
    electrofix
    Moderator

    there will be if you trace the wires back once you remove the covers

    you may have to cut the wires if they dont go back to a seperate terminal

    [USER=”2″]kwatt[/USER] anyway for this person to change the name shown as it shows an email address in a public forum ?

    Dave

    #491209
    electrofix
    Moderator

    should be as long as the wires are securely attatched to the harness

    since you can no longer use the grill its unlikely to get hot enough at the top to cause any problems

    Dave

    #491210
    neelie
    Participant

    Does it matter where I cut them and once there heat shrink tubed and cable tied back together like they were can I put the back back on and have it wired in for use

    #491211
    electrofix
    Moderator

    no does not matter
    cable is heat proof so as long as there is no bare wire to touch anything it will be fine

    Dave

    #491212
    neelie
    Participant

    Thanks I will do that then

    #491213
    neelie
    Participant

    The wires were cable tied to a black wire just under element holes but I had to cut element wires back as the black element wire was bare further over so that’s where I cut it too

    #491214
    electrofix
    Moderator

    yes should be fine
    there is no heat there now the grill is disabled

    Dave

    #491215
    neelie
    Participant

    Thank you I’ll put the back on and get it connected I’ll let you know

Viewing 12 posts - 1 through 12 (of 12 total)
  • You must be logged in to reply to this topic.