F43

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › F43

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 25, 2014 at 4:20 pm #80449
    Washdisher
    Participant

    Siemens WM14s794gb/09

    Replaced worn out brushes
    Reset by turning selector to 6oclock, holding down spin reduction button and turning to 7oclock
    Still displays F43
    Have tried various other combinations, with and without motor plugged in.
    Any suggestions gratefully received.

    Dez

    April 25, 2014 at 5:36 pm #412889
    Martin
    Participant

    Re: F43

    You may have to try it several times, with or without the motor plug disconnected, sometimes.

    Can I just ask : Have you checked you have continuity through the motor, meggered it etc before fitting? As the motor’s TOC could have blown. 💡

    April 26, 2014 at 8:36 am #412890
    Washdisher
    Participant

    Re: F43

    Hi Martin,

    Thanks for that, should have checked motor but was hurried. Motor controller could be worth looking at too I guess.

    Thanks,

    Dez

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.