- This topic has 3 replies, 2 voices, and was last updated 12 years, 4 months ago by
.
-
Posts
-
Good evening all,
Wondering if anyone can advise me with a problem on the above dishwasher, as I have no experience of working on these appliances?
The customer reported a fault with the upper drawer section of the machine; on a normal wash programme the m/c will start at let’s say 54 minutes, and countdown to about 26 minutes, before remaining on this time indefinitely.
This morning I confirmed that during the above cycle water enters, and the wash motor activates.
However, I ascertained that the water temp’ will not rise above tepid at best throughout the cycle.
The lower drawer works fine, and quickly reaches a far warmer temp’ thus I suspect a heater or thermistor problem relating to the upper drawer.
However, I would appreciate some advise/information on this appliance, as I appreciate the fault could also be electronic control/wiring/other related.
Unfortunately, no error codes are being displayed.
Best wishes,
jonty
Re: Fisher & Paykel DD603 DishDrawer Dishwasher Problem
Most likely the heater has failed. To confirm, test continuity through the heater.
Re: Fisher & Paykel DD603 DishDrawer Dishwasher Problem
Thanks for such a rapid response stratfordgirl!
Will return, and test heater.
Do you know if the heater is reasonably accessible, or where I can obtain a wiring diagram?
Kind regards,
jonty
- You must be logged in to reply to this topic.