Fisher Paykel Dishdrawer DD603 F1 Error

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher Paykel Dishdrawer DD603 F1 Error

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 10, 2007 at 8:01 am #24931
    Garyho
    Participant

    Has anybody had one of these give F1 flood error on just the top drawer? 😕

    It did have problems with the lid motors but that has been fixed and everything is dry.

    I have changed both tubs from top to bottom and the top drawer still gives this error. The flood detection board has been replaced. I put in a wiring harness out of another and still the same fault. The service manual mention serveice bulliten DW028 but I don’t have it.

    Any help appreciated.

    Gary Hoffmann

    February 10, 2007 at 9:05 pm #203883
    Penguin45
    Participant

    Re: Fisher Paykel Dishdrawer DD603 F1 Error

    Power failure to lower drawer will cause top drawer to show F1. Suggested course of action is to check the heater plate.

    Penguin45.

    February 11, 2007 at 12:40 am #203884
    Garyho
    Participant

    Re: Fisher Paykel Dishdrawer DD603 F1 Error

    Well I’ll be,

    I was testing with only the top drawer in after replacing the board for the flood detection. Connected both drwaers and 😀 all is good.

    Thank you Penguin

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.