FJS 1225w

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › FJS 1225w

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • May 22, 2009 at 4:54 pm #45923
    Micky 32
    Participant

    When a wash is set at any cycle the display goes from 2hrs down to 3 mins straight away. Brushes etc are ok, is this the pcb? In diagnostic mode it does the same 3 mins comes up.

    May 22, 2009 at 7:23 pm #287644
    Penguin45
    Participant

    Re: FJS 1225w

    Earth leaks on heaters and motors seem to cause all sorts of strange things to happen………

    Chris.

    May 22, 2009 at 10:04 pm #287645
    Micky 32
    Participant

    Re: FJS 1225w

    Also in diagnostic E 85 is coming up, not listed in the book.

    May 22, 2009 at 10:59 pm #287646
    leavemetogetonwithit
    Participant

    Re: FJS 1225w

    E82 and E83 refer to selector reading errors though. It might be worth trying some servisol switch cleaner in there.
    Mike.

    May 23, 2009 at 8:18 am #287647
    lerch
    Participant

    Re: FJS 1225w

    E85 is circ pump, wiring or pcb hope this helps 😀

    May 23, 2009 at 10:31 am #287648
    Micky 32
    Participant

    Re: FJS 1225w

    Thanks 😀 After further reading on here, it seems when the pump goes it brings the pcb with it?? 😡

    May 23, 2009 at 11:02 am #287649
    timdowning
    Participant

    Re: FJS 1225w

    I had one the other day with this fault. Wiring to the circ. pump looked ok
    until I tugged on the wires. One of the wires was broken. New spade connector and all ok.

    May 28, 2009 at 2:04 am #287650
    Micky 32
    Participant

    Re: FJS 1225w

    Problem sorted, thanks for all the replies lads 🙂 It turned out the circulation pump open circuit. Replaced it and all is ok.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.