flashing LED and problem on Whirepool DWF415

[runner]

I have problem with a whirepool DWF415 dishwasher, at beginning of the cycle, machine first start to getting the water in and after about minute the green LED start to flashing with specific pattern, I tried to clean the micro filter but no luck, the machine get the water properly and when it stop if I open the door the machine is full of water, If I press the start again machine start to clean the machine and get the new water in and again stop and LED start to flash with 1,2,3 stop 1,2,3 stop.

any help is appreciated.

Best regards
Runner

[Dave_Conway]

Re: flashing LED and problem on Whirepool DWF415

3 flashes or F3 is a heating related fault.

Possibles are heater, poor connections, main PCB.

Power off if checking yourself or if you need pro help, checkthe repairs@ link below 🙂

Dave.

[runner]

Re: flashing LED and problem on Whirepool DWF415

Thanks for your reply,

actually I tried again, the LED pattern is different, 1,2,3,4,5,6 stop 1,2,3,4,5,6 stop I have got 6 blink and then stop.

Best regards
Mohammad

[Dave_Conway]

Re: flashing LED and problem on Whirepool DWF415

Water “no fill” or not detecting flow problem than 🙂

Dave.

[runner]

Re: flashing LED and problem on Whirepool DWF415

Hi,

I am really appreciate your help, I hope I can fix it myself and save £80
as the callout charge by whirepool is £80 in my area. is there any place which I can look at it myself? Incoming water filter, checking the sensor, this machine has been kept in very bad condition by my tenant (they didn’t clean it for almost 1 year). where is the sensors? is there any way to check and see if sensor working properly?? in washing machine they usually work with air pressure, but I don’t know about dishwashers.

Best regards
Runner

[Author]

Posts