Flashing Lights in HotPoint PCB?

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Flashing Lights in HotPoint PCB?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 9, 2016 at 4:03 pm #88745
    Nixxx206
    Participant

    Hi there,

    Needing some help here with my HotPoint washer/dryer WDL520:

    It goes through the wash cycle till it reaches the drain/spin cycles, when it starts to flash all the lower buttons and the start/stop button.

    I have gone onto check the pcb see if any capacitor is not working but they all seem to be perfectly fine. [pictures attached]

    Any one any pointers as to what I can do next?

    I have attached images of the circuit board. One of the corners seems to be slightly darker but no idea where to continue.

    Any help much appreciated!
    best

    (I have posted images and video here
    http://www.diynot.com/diy/threads/flash … cb.462638/)

    July 9, 2016 at 4:40 pm #439220
    timdowning
    Participant

    Re: Flashing Lights in HotPoint PCB?

    This fault can be caused by the dryer sensor. (NTC)

    July 10, 2016 at 8:24 am #439221
    iadom
    Moderator

    Re: Flashing Lights in HotPoint PCB?

    Ignore the flashing lights, error codes given by right hand vertical lights, numbered from bottom to top. You have lights 1,2,3,4 on steady which is F!5. Supposed to be a heater relay fault on main PCB but as Tim says can often be caused by the dryer NTC.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.