- This topic has 1 reply, 2 voices, and was last updated 17 years, 3 months ago by
.
-
Posts
-
Hi there
After replacing the board and rps approx 7 months ago all was fine until 2 weeks ago when the lid switch wire shorted to ground and blew the board again. I took the machine to be repaired and a new lid switch, board, rps, and display were fitted (I’m told the lid switch damaged all of these).
Now a week later I’m getting 01000001. Can anyone tell me what this code is? If it’s major I’m going to dump the machine, I’m sick of spending $ on it.
Re: F&P MW059NZ code 01000001?
Pressure sensor fault
Pressure Sensor Is part of The Main Motor Controller
Fault Code Suggestts you need a Motor Controller
If this part was replaced by repairer it would be under some sort of warranty
Original Part from FP has A 12 Month Warranty
i suggest you contact repairer.
Alas yes a shorted out lid switch can take out other components
- You must be logged in to reply to this topic.