Haier No spin

[pmb]

HWC1460 otveme-
If i put it on spin ( 11 minutes) It just distrebutes,
Emptys fine, checked presure systom and brushes all O K.
First Haier I have seen,
Any ideas

[kwatt]

Re: Haier No spin

pmb wrote:Any ideas

Petrol, matches and customer education? 😉

K.

(Sorry, couldn’t resist it)

[Martin]

Re: Haier No spin

Does it ramp up to full spin if you take the belt off?

If yes……follow Ken’s advice.

If no……errr?….Ken’s advice still stands.

Be careful though…not too much petrol…OK? 😉 😛

[bazza500]

Re: Haier No spin

Have you tried it empty? These machines are VERY sensitive to OOB loads.

[funkyboogy]

Re: Haier No spin

yip that what i tell these high end appliance customers,
it works better empty ….lol
ps was it in a fancy house merc etc int he drive ??
ally

[helo_75]

you need a modified pcb 😉

[pmb]

Re: Haier No spin

“ you need a modified pcb”
PCB sounds to expensive.
Petrol. Is it that bad ? The control panel is good, easy to use and looks good unlike some new Hoover machines

[helo_75]

no theyre not expensive!!!!

hit the pm button;)

[PGS]

Re: Haier No spin

Try filling this apliance so the load distributes evenly. 9 out of 10 is due to unbalanced / half loads being washed. As said earlier the OOB is very sensitive.

[helo_75]

lol

again

IT WANTS A MODIFIED PCB

and just incase u didnt get it

IT WANTS A MODIFIED PCB

[PGS]

Re: Haier No spin

Any idea of modified Pt No Halo

[johnnyj]

Re: Haier No spin

Got one doing exactly the same, have to break the news to him it needs a pcb, what a pile of s&^{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}te.

[helo_75]

the part numbers no different to the original btw, some have new software on, some dont.. luckily. i can programme them

[PGS]

Re: Haier No spin

Helo what gear do you need to reprog PCBs ?

[BobHope]

Re: Haier No spin

pc software and a hardware interface are required.

Bob.

[Author]

Posts