- This topic has 0 replies, 1 voice, and was last updated 9 years ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
VHC681b machine runs clockwise ok for a while then goes to anti clock and after a few seconds cuts out all lights flash. pulled the board off looking for dry joints none found metered the heater motor etc (ntc 10k5 warm) reassembled and now all seems well. so it might have been poor connector but has anyone seen this before, and can anyone tell me the destination of the low voltage leads just for reference as I didnt do a full strip down. red obviously ntc but not sure of the others.
thanks wilf
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.