hoover dw

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hoover dw

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 7, 2011 at 5:49 pm #60026
    clockworkone
    Participant

    hoover hfi 3015. went to look at this one today.m/c pumps out normally to start with and after a while during wash cycle wash motor starts to go on and off also all lights that are on on programmer follow suit.unable to remove module due to fascia panel being stuck on with some serious adhesive as well as the screws. anyone got any ideas.paul

    January 7, 2011 at 8:01 pm #340464
    loopey
    Participant

    Re: hoover dw

    Have sent you a little lite reading lol .. night time 4 hour wash system what will they think of next , hth

    phil

    January 8, 2011 at 6:49 pm #340465
    clockworkone
    Participant

    Re: hoover dw

    thank you phil have had a read and it answers quite a few common probs.this dw was surging and stopping and programmer lights were going on and off in synchro.customer has told me that over christmas his power was very eratic ie lights would all dim if he put too many appliances on. was wondering if dw could have been spiked with power going up and down.

    January 8, 2011 at 6:55 pm #340466
    Martin
    Participant

    Re: hoover dw

    clockworkone wrote:was wondering if dw could have been spiked with power going up and down.

    Highly likely based on what you tell us. Especially if the voltage goes up then the module is likely as not Christmas Crackered….!. Any mince pies left? 😈

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.