- This topic has 2 replies, 2 voices, and was last updated 19 years ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Customer just rung, needs a belt fitting to one of these. Never done one before but looking at the parts breakdown on the GIAS site it looks like it may be mare of a job. 😥 Any pointers before I go.
Jim.
Re: Hoover SV23 001 Dryer
it is a real pig the back has to come off (sharp edges).the wiring going to
the heater and capacitor comes off note where wires go obviously.
the the heater has to come off and some ducting.
the belt is a stretch fit if i remember no pulleys.
its really just a case of taking as many bits off as required, not difficult but time consuming.
not one of hoovers better designs.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.