Hotpoint Aquarius wma33

[spiderzac]

I have just replaced the main bearing in the above washing machine – unfortunately I lost the piece of paper with the order of the conections to the pcb on the front top of the machine (timer controls etc).

Now all the various cycles etc work but at the end the door wont open. If I move the connectors around the door will open but either the wash or spin cycle wont work! I just cannot seem to get the correct order on the pcb. Either that or is there some kind of system reset I need to do.

Any help / circuit diagram advice will be very much appreciated.

Regards – Roger

[iadom]

Re: Hotpoint Aquarius wma33

spiderzac wrote:I have just replaced the main bearing in the above washing machine –

Just the one bearing. ❓ ❓

Actually the connections to the door lock and motor are all on one single block which can only be attached in one position, to the far right (looking from the front) bottom edge of the board. no system reset, however if you have been trying in a few different positions you may have damaged the board.

Wiring diagrams are copyright so no legitamate sources I’m afraid.

PS. Deleted duplicate post in Dishwasher forum, 😉 😀

[spiderzac]

Re: Hotpoint Aquarius wma33

Thanks for your help.

Regards – Roger

[Author]

Posts