Hotpoint BFI 680 Problems

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Hotpoint BFI 680 Problems

Viewing 3 posts - 16 through 18 (of 18 total)
1 2
  • Author
    Posts
  • March 18, 2013 at 8:18 pm #389390
    Ste3
    Participant

    Re: Hotpoint BFI 680 Problems

    Right I think i’ve got it. There was a lose connector that had 2 thin silver connectors flanked by 2 plastic holding pins. It is now going through a wash. Fingers crossed. Thanks for the assistance so far…

    April 17, 2013 at 11:12 pm #389391
    Ste3
    Participant

    Re: Hotpoint BFI 680 Problems

    Sorry to jump back on this but the issue has reoccurred with the PCB flyhead. Do you reckon this should be soldered to the board because I have disconnect it? It looked ok to do so and came off easily. But the connection now doesnt seem right and the latest flashing light issue happens again. I have noticed that one of the silver pins is shorter than the other. Any suggestions on getting a new flylead? Here are my pics http://sdrv.ms/113UOJZ

    April 18, 2013 at 8:10 am #389392
    iadom
    Moderator

    Re: Hotpoint BFI 680 Problems

    It is not available as a separate part, only comes complete with new pcb. You could try soldering it directly to the board, nothing to loose really.

  • Author
    Posts
Viewing 3 posts - 16 through 18 (of 18 total)
1 2
  • You must be logged in to reply to this topic.