HOTPOINT BWD12

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › HOTPOINT BWD12

Viewing 2 posts - 16 through 17 (of 17 total)
1 2
  • Author
    Posts
  • February 21, 2007 at 11:02 pm #204632
    funkyboogy
    Participant

    Re: HOTPOINT BWD12

    just read this post 10.50 pm wed…
    indespoint your comments were a bit strong,
    but we have all been their,
    i think over the fullness of time you will see that the moderators input to ukw are quite well balanced.

    with reguards to drilling holes into the cracks , this probaly hasnt been recognised in the whitegoods industry..

    ally

    February 22, 2007 at 12:03 am #204633
    iadom
    Moderator

    Re: HOTPOINT BWD12

    funkyboogy wrote:

    with reguards to drilling holes into the cracks , this probaly hasnt been recognised in the whitegoods industry..

    ally
    Ally, drilling holes to stop cracks spreading is a well known, long established practise but it is only a temporary cure. Far better to make the metal involved strong enough for the job in the first place.

    Jim.

  • Author
    Posts
Viewing 2 posts - 16 through 17 (of 17 total)
1 2
  • You must be logged in to reply to this topic.