Hotpoint BWD129

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint BWD129

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • August 27, 2011 at 11:04 am #64724
    chezza
    Participant

    Have one of these to look at , apparently the fault is that the end of the spin, water can be seen coming back into the drum ; Obvious check like drain and filter are fine, but the solenoid is energised even when power off button is off . Unit is around 4 years old , anyone have any words of wisdom for me please 😀

    August 27, 2011 at 2:33 pm #357891
    iadom
    Moderator

    Re: Hotpoint BWD129

    Sounds like a PCB failure to me. 🙁

    Time for EMW perhaps.

    August 27, 2011 at 3:58 pm #357892
    chezza
    Participant

    Re: Hotpoint BWD129

    Thought as much, Jim , is the board one that can be plugged straight in , if bought new, or does it need programming ?

    August 27, 2011 at 6:03 pm #357893
    iadom
    Moderator

    Re: Hotpoint BWD129

    Two different PCB’s four alternative eeprom/smartcard options.


    Test or repair from EMW £6.00 or approx £50.00 with a decent guarantee.

    New, over £100 for pcb & card plus card reader if you don’t have one with no gaurantee whatsoever.

    You choose. 😉

    August 30, 2011 at 5:24 pm #357894
    leavemetogetonwithit
    Participant

    Re: Hotpoint BWD129

    Had a WMA once taking water in during spin and Penguin pointed me to worn brushes (IIRC), and he was right.
    Mike.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.