Hotpoint c367ekh front control panel

This topic has 1 reply, 2 voices, and was last updated 13 years, 5 months ago by allan.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
November 5, 2012 at 5:08 pm #72356

allan
Participant

Bit of advice please? Been out to fit oven door switch on a hotpoint c367ekh freestanding cooker, released all screws at front and rear but it is still held by 3 screws under control facia, took of control and timer knobs, two screws above grill door but can’t move facia, I’m sure I did one before and facia pushed to the left to release but this ones solid didn’t want to start banging it too hard as customer was quite interested to watch!
Am I missing something? Looks like the ceramic top is held on front behind this facia too
Thanks

November 5, 2012 at 7:45 pm #384311

johnnyj
Participant

Re: Hotpoint c367ekh front control panel

2 screws undernesth remove all the knobs and a dunt to the left and it should come off might be stuck due to spillage, on the sponge seal on the top.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.