Hotpoint dish dead FDM550

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint dish dead FDM550

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • November 20, 2012 at 9:59 pm #72636
    pmb
    Participant

    Hotpoint dishwasher FDM550pr
    Dead, but started briefly when I was moving machine, checked terminal block.
    2 boards on control panel, is it one or both of those.
    Is this a common fault.

    November 20, 2012 at 10:07 pm #385112
    HotDog
    Participant

    Re: Hotpoint dish dead FDM550

    Look at wiring behind front panel around metal bar

    November 21, 2012 at 1:16 pm #385113
    pmb
    Participant

    Re: Hotpoint dish dead FDM550

    I had looked at door wiring, but maybe not well enough.
    Trouble is its further then I normally go, And it might not be that.

    November 21, 2012 at 3:16 pm #385114
    iadom
    Moderator

    Re: Hotpoint dish dead FDM550

    Have seen several main pcb’s burnt out on these as well. :rolls:

    November 22, 2012 at 2:58 pm #385115
    pmb
    Participant

    Re: Hotpoint dish dead FDM550

    Does the PCB need programming or is it ready to fit.
    They had smart cards on the Connect Parts.

    November 22, 2012 at 4:40 pm #385116
    iadom
    Moderator

    Re: Hotpoint dish dead FDM550

    Needs programing. 🙁

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.