- This topic has 0 replies, 1 voice, and was last updated 9 years, 5 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hi guys i have a hotpoint FDYF11011G which on the quick wash fills and circulates water normally until the 27 minute when it jumps down to 10 minutes, it then empties fills again and circulates until 8 minutes when it empties and goes to end. There is no fault code displayed, there is no water in the base and the heater is fine. The PCB was replaced recently by someone else. Can anyone point me in the right direction please?
Thanks
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.