- This topic has 1 reply, 2 voices, and was last updated 20 years, 2 months ago by
.
-
Posts
-
Yesterday the dishwasher nearly made it to the end of the cycle (normal wash) when the eco-wash light started flashing, although it sounded like the machine was still working.
I opened it up and there was a lot of water in the bottom, so high it was just touching the bottom washer arm. this morning (water was too hot to do anything last night ) I took out the filters and cleaned them. when i started the machine again, it drained all the excess water within a few seconds, but then the eco-wash light started flashing again.
it doesn’t matter what cycle i try, after about 45 sec. the eco-wash light starts flashing, although the machine is making the normal “noises”, as if it is still working. However there doesn’t seem to be any water coming in ?
I’m not very technical minded, so I hope someone will be able to make sense of this rambling ????Re: hotpoint DWT10
The flood protection system has been activated – water has probably made its way into the undertray. This must be drained and the leak found and corrected.
This is an exceptionally awkward machine to work on, I would recommend getting some pro help – click the link below for a UKW engineer in your area.
Power off if you are going to investigate further.
Regards,
Penguin45.
- You must be logged in to reply to this topic.